rplannerWrapper module

• External module for controlling the rplanner.

Methods:

    to follow

in config.js:

    Load as dependency from:  'https://unpkg.com/[email protected]/dist/rplannerWrapper.js'

in plugin:

    import xxx from '@windy/windy-plugin-module-rplannerWrapper'

Route planner additions:

• You can select a VFR top level higher than FL100. However, the each point along the route has to be loaded separately and this may take about a minute. It is also possible to zoom down to a top level of FL60.
• In the flight planner plugin, you can click read Wx. This reads the wind along the route and corrects the ground speed and the ETE for the leg. The route planner will then use these adjusted data, and will also show the ground speed in the slider line. (For the trajectory plugin, the groundspeed is based on the windspeed along the trajectory).
• A skew-T diagram is added. The top pressure will adjust according to the selected top of the route planner.
• When the skew-T diagram is opened, a brown line will appear, which represents the thermal top. This is dependent on the parcel temperature offset (or shift). By default it is 2 degrees above the surface temperature. As you increase or decrease this offset, the thermal top line will go up or down.