sensa

Control Schlage Sense Smart Locks via Web Bluetooth

Example Usage

Pair a new lock

1. Find your pairing code by removing the cover from the indoor side of the lock.
2. Reset the lock by disconnecting the battery, then holding the "Schlage" key on the outdoor side of the lock while connecting the battery.
3. Enter [code]0 (e.g. if your code is "123456", enter "1234560") on the keypad, and wait for the solid orange light.
4. Run the following command:

node examples/pair.js [code] > .env.FRONT_DOOR

If all goes well, you should see output resembling the following:

Please enter [code]0 on the keypad
subscribing to receive notifications
getting the RX characteristic
getting the primary service
finished getting the primary service
finished getting the RX characteristic
setting up connection
getting the TX characteristic
finished getting the TX characteristic
sending start pairing message
sending pairing timestamp message
authorizing with temporary auth token
calculating client/server session keys
sending authorization challenge
sent
creating secure session
authorizing secure session
started secure session for lock SENSEABCDEF
claiming ownership of lock
disconnecting

Note: If you see Request error: 145 or Timed out, just start over. The timing can be a bit finicky.

Lock the deadbolt

node --env-file=.env.FRONT_DOOR examples/lock.js

Unlock the deadbolt

node --env-file=.env.FRONT_DOOR examples/unlock.js

Set access code length

node --env-file=.env.FRONT_DOOR examples/setAccessCodeLength.js 6

Get access code length

node --env-file=.env.FRONT_DOOR examples/getAccessCodeLength.js

Add access code

node --env-file=.env.FRONT_DOOR examples/addAccessCode.js 123456

Delete access code

node --env-file=.env.FRONT_DOOR examples/deleteAccessCode.js 123456

Get access codes

node --env-file=.env.FRONT_DOOR examples/getAccessCodes.js