nvl4wq3q9_t2l
v1.0.0
Published
nvl4wq3q9
Downloads
1
Readme
Port 0002 Hub 0003 Driver Zip
Port 0002 Hub 0003 Driver Zip ->>> https://urlin.us/2tj74d
i did the following to setup the hub3000: 4. load the driver and register the usb interface. 5. install a driver for the new device (connected serial cable). 6. set the device to 'available' in the device manager. 7. start or restart the pc and the device will be shown. 8. shutdown the pc. 9. remove the usb cable. 10. re-install the driver and connect the hub3000 to the serial port. you will have to re-register the usb interface.
hello all. i recently purchased a radxa zero and installed ubuntu 18.04 on it. when i connected it to my tv and power it up the screen goes black. i tried with both hdmi and vga port. the screen is the same for both. this is also when i tried for the first time. i followed the instructions and while clearing the emmc i was able to access it again. but the issue continues. i tried formatting it and my other usb pen drive but the same issue. the only way i could access the device was by removing and reinstalling the driver. while uninstalling the driver i also get a message that my device has not been recognized and i am supposed to setup the driver (which i have already done). can someone please help me through this issue.
i've been trying to use my harmony one remote on my ipad 6 plus running an osx mojave v.10.14.6. i've gone through plenty of fixes as outlined in this blog and those on the discord and github. although i appreciate all of the effort, none of the solutions work. i'm hoping someone here can help. the logitech harmony one works fine on the ipad so it must be an osx issue. i've enabled rootless mode in the settings and remoted back on to get the usb id but still nothing. in order to figure out what the usb id is i have to enable the remotes usb service in settings. i can get it to load in device manager but then nothing happens when i try to pair the remote via the.jar. 84d34552a1