ms5611
v1.0.0
Published
`node-ms5611` is a node module which makes it easy to interact with [MS5611 digtal pressure and temperature sensors](https://www.te.com/commerce/DocumentDelivery/DDEController?Action=showdoc&DocId=Data+Sheet%7FMS5611-01BA03%7FB3%7Fpdf%7FEnglish%7FENG_DS_M
Downloads
1
Maintainers
Readme
node-ms5611
node-ms5611
is a node module which makes it easy to interact with MS5611 digtal pressure and temperature sensors. It communicates with the sensor via i2c.
Example Usage
import ms5611 from 'ms5611';
const address = 0x77; // i2c address - use i2cdump to find this
const bus = 1; // i2c bus
// start i2c communication
const { getValues, close } = await ms5611(address, bus);
// read temp and pressure
const { temp, pressure } = await getValues();
console.log(`temp in celsius: ${temp.toFixed(2)}`);
console.log(`pressure in millibar: ${pressure.toFixed(2)}`);
// clean up any resources associated with i2c bus
await close();
Raspberry Pi Setup
To use this module with a raspberry pi, you'll need to do a few things first:
- Enable the i2c bus using
raspi-config
- Run
sudo raspi-config
- Navigate to Interface Options > I2C > Yes
- Run
- Connect the sensor to your pi
- Determine the address for your sensor:
- Install i2c-tools:
sudo apt install i2c-tools
- Run
sudo i2cdetect -y <bus>
, where bus is 1 or 0 depending on your pi model. The address of all i2c devices connected to your pi will be printed to stdout.
- Install i2c-tools:
- Run the example code above with the values for address and bus