homebridge-watchdog15

Homebridge plugin for the Vertiv Geist Watchdog15 Temperature/Humidity Sensor

Installation

First of all you need to have Homebridge installed. Refer to the repo for instructions.
Then run the following command to install homebridge-watchdog15

sudo npm install -g homebridge-watchdog15

Configuration

The configuration can contain the following properties:

Basic configuration options:

• accessory <string> required: Defines the plugin used and must be set to "Watchdog15" for this plugin
• name <string> required: Defines the name which is later displayed in HomeKit
• ip <string> required: Defines the IPv4 address of the Watchdog 15 on the local network

Advanced configuration options:

• warningHiTemp <number> optional (Default: "none"): Defines a high temperature limit, which if exceeded, generates a fault notification in HomeKit. The value should be in the same units of measure configured in the Watchdog15 web interface.

• warningLoTemp <number> optional (Default: "none"): Defines a low temperature limit, which if exceeded, generates a fault notification in HomeKit. The value should be in the same units of measure configured in the Watchdog15 web interface.

• warningHiHumidity <number> optional (Default: "none"): Defines a high humidity limit, which if exceeded, generates a fault notification in HomeKit. The value should be in the same units of measure configured in the Watchdog15 web interface.

• warningLoHumidity <number> optional (Default: "none"): Defines a low humidity limit, which if exceeded, generates a fault notification in HomeKit. The value should be in the same units of measure configured in the Watchdog15 web interface.

• warningHiDewpoint <number> optional (Default: "none"): Defines a high dewpoint limit, which if exceeded, generates a fault notification in HomeKit. The value should be in the same units of measure configured in the Watchdog15 web interface.

• warningLoDewpoint <number> optional (Default: "none"): Defines a low dewpoint limit, which if exceeded, generates a fault notification in HomeKit. The value should be in the same units of measure configured in the Watchdog15 web interface.

• updateInterval <number> optional (Default: 60): Defines the update interval (in seconds) to refresh the data from the Watchdog15. Default is 60 seconds. Homekit calls to get data between these updates will return a cached value from the last update.

Example config.json

{
    "accessories": [
        {
            "accessory": "Watchdog15",
            "name": "Basement",
            "ip": "192.168.1.45"
        }
    ]
}

This accessory will create a Watchdog15 sensor with Temperature, Humidity, and Dewpoint monitoring at the IP address 192.168.1.45. It will update the sensor state once a minute.

Advanced example config.json

{
    "accessories": [
        {
            "accessory": "Watchdog15",
            "name": "Basement",
            "ip": "192.168.1.45",
            "updateInterval": 5,
            "warningHiTemp": 115,
            "warningLoTemp": 34,
            "warningHiHumidity": 70
        }
    ]
}

This accessory will create a Watchdog15 sensor that updates every 5 minutes with high and low alarms on temperature and a high alarm on humidity.