Homebridge-Robonect

Development ongoing.

This plugin will:

• Fetch battery level / low battery warning
• Fetch charging status
• Simulate mowing with a fan accessory (tap to toggle mode when running (see config table))
• Provide an "on/off"-switch for toggling auto or home mode.

Usage

npm install -g homebridge-robonect

NB Robonect H30x-users, see below for instructions.

Config as follows:

{  
	"accessory": "HomebridgeRobonect",  
	"name": "name-of-your-mower",  
	"mower": "Mower make",  
	"model": "Mower Model",
	"serial-number": "Serialnr of your mower",
	"pollingInterval": time-in-seconds,  
	"getUrl": "http://USER:PASS@SERVER:PORT"  
}  

| Parameter | Description | Default | Type |Optional | |:--|:--|:-:|:-:|:-:| | accessory | Always "HomebridgeRobonect" | "" | String | no | | name | The name of your mower, as you want it to appear in the Home App | "" | String |no | | mower | The manufacturer of your mower. I.e. "Husqvarna" or "Gardena" | "" | String |yes* | | model | Your mower model. I.e. "Automower 305" | "" | String |yes* | | serial-number | The serial number of you mower| "" | String |yes* | |pollingInterval| Set the interval for polling the mower. Cannot be set lower than 30s. | 60 | int | yes | |fanMode| Choose what toggling the fan off/on should do. 0 = eod/auto, 1 = stop/start | 0 | int | yes | |showHealth| Choose whether you want to show the temperature and humidity sensors. 1 = show, 2 = don't show | 1 | int | yes | | getUrl | The URL to your mower. PORT is optional. | "" | String | no |

*Only optional in versions >1.1.10

Robonect H30x users

Robonect H30x is only supported in version 1.0.22 and older, which can be installed using npm -g install [email protected] Additional options to configure are: | Parameter | Description | Default | Type |Optional | |:--|:--|:-:|:-:|:-:| | show-humidity | Set to either yes or no, to enable the humidity sensor (valid for version 1.0.22 or older) | "yes" | String | yes | | robonect-card | Robonect card type. Either "H30x" or "HX".| "" | String |no |

• Input "HX" in capitals as robonect-card ONLY if you have a Robonect HX! You'll get the temp from the temp sensor, rather than the battery. :)

Discuss the plugin with me and others, here.