homebridge-platform-yoctopuce

A Yoctopuce.com platform plugin for Homebridge.

Installation

Run these commands:

% sudo npm install -g homebridge
% sudo npm install -g homebridge-platform-yoctopuce

On Linux, you might see this output for the second command:

npm ERR! [email protected] install: node-gyp rebuild
npm ERR! Exit status 1
npm ERR!

If so, please try

% apt-get install libpcap-dev

and try

% sudo npm install -g homebridge-platform-yoctopuce

again!

NB: If you install homebridge like this:

sudo npm install -g --unsafe-perm homebridge

Then all subsequent installations must be like this:

sudo npm install -g --unsafe-perm homebridge-platform-yoctopuce

Configuration

If you're already running homebridge on your system, then you already have a ~/.homebridge/config.json file and no configuration is needed!

This is a "dynamic" platform plugin, so it will automatically look for Yoctopuce Hubs on the local network that respond to SSDP discovery requests.

If this is your first time with homebridge, this will suffice:

{ "bridge"       :
  { "name"       : "Homebridge"
  , "username"   : "CC:22:3D:E3:CE:30"
  , "port"       : 51826
  , "pin"        : "031-45-154"
  }
, "description"  : ""
, "accessories"  :
  [
  ]
, "platforms"    :
  [
    { "platform" : "homebridge-platform-yoctopuce"
    , "name"     : "Yoctopuce"
    }
  ]
}

Supported Sensors

• Yocto-CO2
• Yocto-Light-V3
• Yocto-Meteo
• Yocto-4-20mA-Rx (for CO and NO2)

If you add others, please submit a pull request.