homebridge-aquanta Plugin

homebridge-aqunta is a Homebridge plugin with integrates with the Aquanta Water Heater controller.

homebridge-aqunta supports the current Water Heater Temperature, Boost Mode Switch, and Away Mode Switch.

Installation

You need to have Homebridge installed. Refer to the repo for instructions.

Then run the following command to install homebridge-aqunta

sudo npm install -g homebridge-aqunta

Configuration:

Configuration sample (edit ~/.homebridge/config.json):

    "platforms": [
        {
            "email": "[email protected]",
            "password": "password",
            "platform": "Aquanta"
        }
    ]

• email <string> required: The email address for your Aquanta Portal account.
• password <string> required: The password for your Aquanta Portal account.
• platform <string> required: Must be "Aquanta"

Known Limitations

Only works with a single Aquanta unit associated to your account. If you have multiple Aquanta units and would like to use this plugin, please open an Issue to request functionality. I may need some information from you to fully implement.

Note: The developer of the homebridge-aqunta is not associated with the Aquanta company.