@silviokennecke/homebridge-gpio-garage-door
v1.0.0
Published
Use GPIO output as HomeKit garage door
Downloads
44
Maintainers
Readme
Homebridge GPIO garage door
This plugin uses the GPIO output of the Raspberry PI to provide a HomeKit garage door.
:warning: This plugin is only designed for and tested on Raspberry PI. There's no guarantee, the plugin works also on other boards equipped with GPIO!
Configuration
| key | type | description | |-------------------------|---------|------------------------------------------------------------------------------------------------------------------------------------------------| | name | string | The name of the accessory. | | gpioPinOpen | integer | The GPIO pin the plugin should use to open the garage door. | | gpioPinClose | integer | The GPIO pin the plugin should use to close the garage door. If empty, gpioPinOpen is used to open and close the garage door. | | emitTime | integer | How many milliseconds should the GPIO output be HIGH? | | executionTime | integer | How many seconds does the garage door to execute an open or close command? | | allowCommandOverride | boolean | If true, the plugin will allow to send a new command (e.g. open) to the garage door while it's already executing another command (e.g. close). | | reverseOutput | boolean | If enabled, a open signal will be sent as HIGH-LOW-HIGH, instead of the default behaviour LOW-HIGH-LOW. | | gpioStateInputEnabled | boolean | If enabled, the plugin will read the current state of the garage door from the GPIO input. | | gpioPinState | integer | The GPIO pin the plugin should use to read the current state of the garage door. | | gpioStateInputReverse | boolean | If enabled, a GPIO HIGH state will indicate a CLOSED garage door. | | webhookEnabled | boolean | If enabled, the plugin will listen on the configured port for a webhook to changes of the garage door state, emitted by an external sensor. | | webhookPort | integer | The port the plugin should listen on for a webhook. | | webhookPath | string | The path the plugin should listen on for a webhook. | | webhookJsonPath | string | The JSON path to the value of the garage door state. A truthy value indicates an open garage door. | | webhookJsonValueReverse | boolean | If enabled, the plugin will reverse the value of the JSON path. E.g. a truthy value will become falsy. |
Support & Contribution
This project is not commercially developed or maintained. Therefore, it might take some time after opening an issue until it is solved. But anyway: If you experience any bugs feel free to open an issue or create a pull request. Contribution is always welcome.