@itentialopensource/cisco-ios-upgrade
v0.4.4-2022.1.1
Published
[Deprecated] Itential automation Artifact for cisco ios device upgrade
Downloads
14
Readme
Deprecation Notice
This Pre-Built has been deprecated as of 07-12-2024 and will be end of life on 07-12-2025. The capabilities of this Pre-Built have been replaced by Cisco - IOS - IAG.
Table of Contents
- Overview
- Features
- Installation Prerequisites
- How to Install
- Supported Device Types
- How to Run
- Additional Information
Overview
This pre-built contains the Cisco IOS device upgrade workflow for NSO and Ansible using IAP. The workflow requires that a newer binary version file is already downloaded locally on the destination device (bootflash:), and file integrity has been verified (using md5). To satisfy these pre-requirements, use the file-transfer pre-built available from Itential.
This solution consist of the following:
Main Workflow (IAP-Artifacts IOS Device Upgrade)
- Perform device environmental checks. Verifies a device is on a different version than the requested one.
- Perform pre-checks to confirm device readiness.
- Backup the running-config locally on flash drive.
- Perform boot statement configuration to direct the router to load the newer version upon the next boot.
- Issue the reload command.
- Wait for device to become available after reboot.
- Confirm reliable connectivity (ping consistency).
- Perform post-checks to verify the device functionality running the new version.
- Show a Pre-Post Checks diff report.
- Perform MOP analysis to verify no unexpected config changes occurred.
- Show a MOP analysis report.
- Perform rollback, if requested.
Command Templates
- Will run the pre / post commands and evaluate them against set thresholds.
Analytic Templates
- Will run the pre vs. post comparisons and evaluate them against set thresholds.
Automation Catalog Entry with a JSON-Form:
- Mode selection: Zero-Touch, Normal, or Verbose
- Allows user to pick destination device to run the upgrade on.
- Allows user to pick software version to upgrade to (file names are hard coded in JSON form).
- Ping-consistency variables
Features
- Automatically find device orchestrator Ansible or NSO.
- Perform readiness checks prior to any change, and functionality verifications after changes have been applied.
- Allow for a rollback in case functionality checks have failed.
- Show a conclusive report with the Pre vs. Post config diff.
Installation Prerequisites
Users must satisfy the following prerequisites:
- Itential Automation Platform
^2022.1
How to Install
To install the pre-build:
- Verify you are running a supported version of the Itential Automation Platform (IAP) as listed above in the Prerequisites section.
- The pre-build can be installed from within
App-Admin_Essential
. Simply search for the name of your desired pre-build and click the install button.
Supported Device Types
- Cisco IOS
How to Run
Starting an IOS device upgrade can be invoked via Automation-Catalog. Navigate to the Automation-Catalog app and press run on the IAP Artifacts IOS Device Upgrade entry.
Additional Information
Please use your Itential Customer Success Account if you need support when using this pre-built.